JIAXING PASSION NEW ENERGY TECHNOLOGY CO., LTD.
JIAXING PASSION NEW ENERGY TECHNOLOGY CO., LTD. Solar Water Heater, Solar Collector, Flat Panel manufacturer
Add to Cart
Copper Pipe Solar Collector Heat Pipe Solar Panel Non Pressure Solar Collector Pressurized Glass Tube Geysers
Heat Pipe solar Collector
It used with heat preservation water tank, solar power workstation and the heat pipe collector.
The solar collector is consisted of super conducting vacuum heat collecting tube and header, so it's of great efficiency of heat collecting.
The absorbing percentage of the glass vacuum collector is more than 94%.
In the sunny days of spring or autumn, each collecting tube could make the water up to 90 degrees centigrade only in 2.5 hours.
Heat pipe solar collector working principle
1) Solar absorption: solar radiation is absorbed by the solar tubes and converted into heat.
2) Solar heat transfer: heat pipes conduct the heat from within the solar tube up to the
header pipe.
3) Solar energy storage: water is circulated through the header, via intermittent pump cycling.
Each time the water circulates through the header, the temperature is raised by 5-10C.
Throughout the day, the water in the tank is gradually heated.
Advantage:
• Material of manifold is SUS304 stainless steel or aluminum alloy
• Copper heat pipe for rapid heat transfer.
• Max Pressure bearing: 8bar.
• ISO9001 / CE certificate/EN-12975.
• 5 years warranty.
• Corrosion resistant brazed copper header.
• Attractive design, standard frame suitable for pitched roof or flat roof .
• Easy plug-in installation.
• Improves the environment and save your fuel cost.
Technical datas:
| Model | PT-C-15 | PT-C-18 | PT-C-20 | PT-C-24 | PT-C-25 | PT-C-30 |
| Tube QTY(PCS) | 15 | 18 | 20 | 24 | 25 | 30 |
| Three Target Vacuum Tube | Diameter/Length: φ58mm/1800mm; High boron and silicon content 3.3; Structure:Gradual change SS-AL-Nx/Cu selective absorption coating; Vacuum Degree:P<=5*10-3; | |||||
| Heat Pipe | Condesor: φ14/φ24*70mm ; Thickness: 0.5mm ; Material: red copper TU1+water; Transfer Power:>=150W; Working Pressure:4Mpa; Welding Pressure:4Mpa; | |||||
| Outer Shell/Bracket | Alluminum Alloy,Silver | |||||
| Insulation Layer | Rock wool | |||||
| Dustproof Rubber | EPDM | |||||
| Dsily Heat Gain | 8.5MJ/m² | |||||
| Work Pressure | 0.6MPa | |||||
| Inlet/outlet | 22mm/3/4" | |||||
| Tailstock | ABS | |||||
| Temperature | 250 °С | |||||
| Contour Aperture Area | 2.32m² | 2.75m² | 3.10m² | 3.64m² | 3.78m² | 4.52m² |
| Aperture Area | 1.43m² | 1.70m² | 1.89m² | 2.27m² | 2.36m² | 2.83m² |
| Absorption Area | 1.22m² | 1.46m² | 1.62m² | 1.95m² | 2.04m² | 2.43m² |
Quality Policy:
products regular :≥99%
QC before output :100%
Replace free of the bed products:100%
Guarantee :5 years
We can also produce according to your requirement.And OEM is also provided.
